up level       

 LED CHANNEL-FLEX PCB TYPE ( vertical )  
     LED CHANNEL-FLEX PCB TYPE(VERTICAL) is a new member of the PCB LED family. It consists of flex circuit board which can be bent at any angle and LEDs which are soldered on the circuit board. So this one has better flexibility than PCB that uses normal conductors as copper and wire. Each unit includes three LEDs. You can cut between units to get your desired length.
      On the side of the light body, there are power connectors. You can extend the length of the light by using these connectors. This product also provides an easier installation system than that of other PCB products
  
   • SPECIFICATION :

    1. Operates under a low voltage of 12V and is safe to use..
    2. Uses flex circuit as conductor with a bendable angle of 360o
    3. Each unit consist of 3 bulbs. The product can be cut into various units.

     • Installation : 

              The same with the LEDCHANNEL-Flex

     • Caution :  

     1. Unplug the power during cutting.
    2. Cut only at the cutting mark.
     3. Do not plug the power during installation. Spacing between two belts should be wider
        than 1/2". channel can not be stuck together to avoid over heat

     • Packaging :

              Packed in roll : 60Ft/RL

     •  Technical Parameters :
Item No.
Bulb NO.
 Voltage spacing Length in Roll
Power Consumption
Max in roll
Max. Length Color Led Life
LBLU (FX)-V-60-12V
1440
12VDC
1/2"
60Ft
1.92 W/Ft
60Ft
12.5Ft
R/G/Y/
B/W
100000HRS
 

           • How to set up
Straight line

Right Angle
Curve
1. Cut only at the cutting mark.
2. Channels can be connected by extension cord .


3. Connect the transformer and
LEDLINE-FLEX PCB TYPE(vertical) together with connector.

4. Fix with screw and clip if necessary.
5. Stick with double sided tape.

Copyrights 2006 by NeoNeon.co.th., All Rights Reserved Designed by Siammetal Services